How to Program an ATA Remote: PTX4, PTX5, PTX6 Guide

What You'll Need

• Your new ATA replacement remote (PTX4, PTX5, or PTX6)
• Access to your garage door motor
• 2 minutes

Understanding ATA SecuraCode

ATA (Automatic Technology Australia) remotes use SecuraCode rolling code technology. Each time you press the button, a new code is generated — this prevents code grabbing and replay attacks. The pairing process teaches your motor to recognise your remote's unique code sequence.

Step 1: Find the Learn Button

On ATA motors, the Learn button is usually: - PTX4-compatible motors: Small button on the motor head, often marked with a code symbol - PTX5-compatible motors: Button on the side or back of the motor unit - PTX6-compatible motors: Similar location, may be under a rubber cover

The button is typically black or red and about the size of a pencil eraser.

Step 2: Press the Learn Button

1. Press the Learn/Code button once
2. The motor's LED will illuminate or start flashing
3. You now have approximately 10 seconds to pair your remote

Step 3: Program the Remote

1. Press and hold the desired button on your ATA remote
2. Keep holding for 2-3 seconds
3. The motor LED will flash rapidly or you'll hear a click
4. Release the button
5. Press the button again to test — the door should activate

Step 4: Program Additional Buttons

For multi-button remotes (PTX4 has 4 buttons, PTX5 has 3-4, PTX6 has 4):

1. Press Learn again
2. Press and hold a different button
3. Repeat for each button you want to program

Each button can control a different door or function.

Model-Specific Instructions

ATA PTX4 (SecuraCode, 4-Button) The most popular ATA remote. Operates on 433.92MHz with rolling code. Programming is straightforward — Learn button on motor, then press remote button.

ATA PTX5 (TrioCode, 4-Button) The PTX5 uses **TrioCode** technology which operates on **three frequencies** (433.92MHz, 915MHz, and another) for improved reliability in areas with interference. The programming process is the same as PTX4.

ATA PTX6 (SecuraCode, 4-Button) Similar to PTX4 but with a different form factor. Same rolling code technology and programming method.

Clearing All Remotes

If you've lost a remote and want to start fresh:

1. Press and hold the Learn button for 8-10 seconds
2. The LED will flash rapidly then go out
3. All remotes are now erased from the motor's memory
4. Re-pair each remote you want to keep

Troubleshooting

Remote won't pair after multiple attempts? - Check the battery — ATA remotes use CR2032 (PTX4) or 12V 27A (PTX5/PTX6) batteries - Make sure you're using the correct remote for your motor — PTX4 and PTX5 are not interchangeable despite looking similar - Stand closer to the motor during pairing (within 2 metres)

Door responds to wall button but not remote? - The remote battery is likely flat — replace and try again - If a new battery doesn't fix it, the remote may be faulty — contact us for a warranty replacement

One button works but others don't? - Each button needs to be programmed separately - Press Learn, then press and hold the unprogrammed button

Need Help?

Contact us at shane@allremotes.com.au or browse our [ATA replacement remotes](/brands/ATA).

Safety Note

Always keep garage door remotes out of reach of children. The button battery in ATA remotes can be dangerous if swallowed. Ensure the battery compartment is secured.